Bathroom hardware installation is the details of the renovation and construction, need to be carefully handled:
Before installing the faucet, thoroughly rinse the water supply pipeline first, remove the impurities in the pipeline, and check whether the water supply pipeline is damaged. When installing, pay attention to the cold and hot water supply pipes. Do not install the reverse. After installation, remove the bubbler. , showers and other easy to block accessories, let the water out, and then put it back.
Before installing the floor drain, first remove the ground drain core to prevent the debris from falling into the affected effect. The drain pipe should be filled with cement mortar away from the ground. Increase the drain pipe and cut off the appropriate amount of the drain pipe so that the floor drain is slightly lower than the ground.
After the installation of the large-sized products, the bathroom accessories are installed again, and the impact drill is required on the wall. It is recommended that the professional master use a glass drill bit to first open the hole of the tile and then use the impact drill to hit the cement, thus avoiding cracking the tile. When installing, determine the location of water pipes and wires according to the water circuit and circuit diagram. Be sure to avoid water pipes and wires. In addition, you cannot directly touch the hardware, and then tighten it with a clean soft cloth.
Stainless Steel Camlock Dc,Cam Lock Set,Cam Lockers,Standard Cam Lock
Hebei Yuanbai Technology Co., Ltd. , https://www.yuanbaikeji.com