The working principle of the rice cooker is shown in the figure. Place the inner pot of the food on the heating plate so that the bottom is attached to the temperature-sensitive soft magnet at the center of the heating plate. When the key switch is pressed, the permanent magnet under the soft magnet rises to contact with the soft magnet; at this time, the pot has not heated up, the soft magnet is below the Curie temperature, and it is ferromagnetic and can be magnetized by the permanent magnet and held high. Point location. The soft magnet at the high position drives the internal lever to open the upper and lower contacts of the circuit, and the electric heating element is energized and heated, and the food in the pot is heated and heated. When the inner bottom temperature reaches 103±2°C (this is the Curie temperature of the soft magnet), the soft magnet immediately senses and loses its magnetism, and falls from the high point under the action of gravity and internal spring, and thus drives the lever. The mechanism causes the upper and lower contacts of the circuit to be detached, the circuit is disconnected, and the electric heating element of the rice cooker no longer generates heat, thereby achieving the purpose of temperature limitation. However, at this time, the heating plate is still in a high heat state, and its heat capacity is large, and the food in the pan can be heated for a while until the food is cooked. In order to maintain the food at a suitable temperature, some rice cookers are also equipped with a low-power heating circuit, and a bimetal thermostat is used to control the operating temperature.
Socket-Weld Flanges has a female socket in which pipe is fitted. Fillet welding is done from outside on the pipe. The socket welding flange is similar to a slip-on flange except it has a bore and a counterbore dimension.
The counterbore is slightly larger than the O.D. of the matching pipe, allowing the pipe to be inserted into the flange similar to a slip-on flange.
The diamter of the smaller bore is the same as the I.D. of the matchine pipe A restriction is built into the bottom of the bore which sets as a shoulder for the pipe to rest on.
Weld Flanges,Socket Weld Flanges,ANSI Socket Weld Flanges,Steel Socket Weld Flanges
Shandong Zhongnuo Heavy Industry Co.,Ltd. , https://www.znforged.com