First, dismantle and clean up
Because the wall renovation is generally a second renovation, the first priority is to carry out the demolition and cleaning work, including “removing old doors and windows, shoveling the original wall surface, knocking out the original tiles and the ground, etc..... The time required for the work varies according to the different areas and workloads of different homes. For example, a house of 60 square meters usually takes about 5-6 days. To change the window, one more thing to mention, generally speaking, installing windows It is ok to finish the wall, the gargle and the wall tile. However, it usually takes a few days to install the window from the window to the door, so you can start early.
Second, wall and floor tile laying
After the completion of the hydropower and the acceptance of the inspection, the paving work of the wall and floor tiles can be carried out. Generally, the wall tiles of the bathroom, the kitchen or the balcony are laid first, and then the floor tiles are used. This is because the first floor tile in the wall tile may cause the wall tiles. Damage and cleaning work are also cumbersome. If the home is equipped with a floor, it is necessary to wait until the wall is finished with paint.
Third, the wall treatment
After the tiles are laid, you can handle the wall surfaces of the bedroom, living room and dining room, including leveling, repairing cracks, scraping putty, etc., and then brushing the latex paint. It is also possible to measure cabinets and ceilings. The reason why the cabinet measurement is carried out at this time is that the size of the main tile is relatively accurate, and the size of the tile is estimated in advance. At the same time, it should be noted that the general cabinet needs to wait for about 10 days.
Fourth, the installation
After brushing the wall paint, or when painting the last coat, you can install the door and the mouth. The door production time is about 15 days. Therefore, according to this time, the lamp, panel, and sanitary ware are installed. Wait. If you have furniture for making woodwork, you can paint it after brushing the latex paint.
Pay attention to the following situations when painting walls:
1, the temperature of the day of painting, if the temperature is above 20 degrees, it is relatively dry, then brushing the wall paint twice a day is possible, but pay attention to the interval time, the general interval should be more than 2 hours;
2, the humidity in the air, if the humidity is large, or it is rainy weather, it is recommended not to paint, to prevent the paint film from absorbing water and foaming;
3, if the humidity is moderate, the temperature is also suitable, you can brush twice a day; but also pay attention to the brush separately from the polyester paint to prevent the reaction, resulting in yellowing of the latex paint film;
4. In addition, if the color of the paint in the home is more than 2 kinds, and the color of the roof and the wall is not the same, it should be brushed separately to avoid color confusion and repeated washing of the waste material.
Brush the topcoat. The top coat is usually brushed twice, and each time should be separated by 2-4 hours or more (depending on the dry time) until it is basically dry. After the second coat is finished, it takes 1-2 days to completely dry out. Before the paint is completely dry, it should be waterproof, drought-proof, and sun-proof to prevent problems with the paint film.
Metallographic Cutting Machines
Cutting is the first step of material analysis. The selection of cutting machine and cutting wheel must comply with the geometric size and material characteristics of the sample. The perfect metallographic cutting should avoid microstructure thermal damage and deformation, and preserve the necessary accuracy and efficiency.Hardness and ductility are the two main parameters for selecting the cutting wheel. The best choice of the cutting wheel depends on the size, hardness and ductility of the material and the equipment used. Trojan's cutting products speak with facts and the cutting process is simple, fast and accurate.
Metallographic Cutting Machines,Metallographic Cutting Equipment,Metallographic Cut-Off Saw Equipment,Metallurgical Sample Cutting Machine
TROJAN (Suzhou) Technology Co., Ltd. , https://www.trojanmaterial.com