In order to prevent insects, the first is to purchase the floor produced by the dry kiln steaming process. Although the price is relatively expensive, all the eggs in the wood have been killed. Second, the keel is carefully selected, and there are insects or bark. , no need to.
Quilting
Some floors were laid for a few days, and there was a big gap between the slats. Most of this is related to the high moisture content before the floor is laid, and it shrinks due to high temperature or air drying in the room. Note that the moisture content before laying the floor should be between 8% and 13%, and oil should be applied in time after the paving.
sound
Due to the low quality of the floor laying, people will make a creaking sound when walking around. To this end, pay attention to the keel and the ground, the nail between the floor and the keel should be nailed firmly, and the number and length of the nails should be appropriate. At the same time, it is necessary to prevent the quantity and length from being appropriate. At the same time, it is necessary to prevent the keel spacing from being too large or the water content to be too high, otherwise the drying and shrinking looseness after laying will also have a certain impact.
Dirty board
It means that some floors are painted, giving an unclean "ash" feeling, and some even the footprints are clearly visible. To avoid this, it is important to keep the surface of the board clean before polishing.
Drum
To ensure that the floor does not bulge, pay attention to three points:
1. At the end of the civil works, solid wood flooring cannot be laid immediately;
Second, if the living room is located in a humid environment, it is advisable to lay a moisture-proof floor;
3. When laying, the moisture content of the floor should not be lower than 6%. The main reason is that the solid wood floor is not caused by the regular drying treatment, so the plastic can be laid under the floor during installation. In addition, the floor is placed in the room to be laid two days in advance, so that the wood can be adapted to the temperature in the room and can also prevent warping.
5 bars LED Grow Light is a kind of lamp that provides light for plants. It usually consists of five light bulbs, each representing a claw, which can provide plenty of light and lighting effects.
The use of the 5 bars led grow lights can be described according to the following aspects:
1. Light time: According to the needs of plants, the use time of 5 bars growth lights can be adjusted according to different stages and types. Generally speaking, the time that plants need light is generally about 10-12 hours.
2. Light intensity: The light intensity of the 5 bars grow light can be adjusted according to different plant types and growth stages. For plants that need stronger light, the lamps can be placed in a closer position to provide stronger light.
3. Lighting range: The lighting range of the 5 bars indoor grow light depends on the design and installation position of the lamp. In general, the lamp should be able to cover the entire growing area of the plant to ensure that the plant can fully receive the light.
4. Use environment: 5 bars plant lights can be used in both indoor and outdoor environments, but they are usually more suitable for indoor use. In the indoor environment, the lamps can be placed in different positions as needed to meet the light needs of the plants.
In general, the use of the 5 bars plant grow light should be adjusted according to the needs of the plant and the growth environment. Through reasonable light time, light intensity and lighting range, it can provide suitable light conditions for plant growth and promote the growth and development of plants.
5 Bars Led Grow Light,Grow Lights For Indoor Plants,farmer Indoor Grow Lights,Grow Lamp
Shenzhen Pvison Technology Co., Ltd. , https://www.pvisunggrowlight.com