Maybe you also cherish the newly renovated new home, so you can't miss this kind of thing, that is the wall corner protection. In fact, it also has many types, the following small series will give you an introduction to the living room corner protection . Let's take a look at what it does!
What is a wall corner strip?
The corner protection strip is a kind of section material used on the wall to make the corner shelf more neat and beautiful. In addition to the appearance, the corner protection strip reinforces the corner of the corner at the same time to avoid dents and other damage on the corner of the corner.
Living room corner protection
The corner strip has the advantages of corrosion resistance, impact resistance, anti-ageing, good adhesion, full integration with putty, etc., greatly enhancing the impact resistance of the corner, maintaining the long-term appearance of the corner without being destroyed, and can be implemented synchronously with the main project. In the process of use, it is not necessary to use a ruler board, which is easy to operate and the construction efficiency is 2 to 5 times that of the 11th class, which simplifies the construction procedure, speeds up the construction speed, reduces the engineering cost, and improves the project quality.
The corner protection strips can form a right-angled edge on the ridgeline of the plasterwork to resist cracking or cracking, and protect and reinforce the most vulnerable parts of the stucco. The netting wings can be firmly embedded in the plaster on either side of the ridgeline. The full depth of the mud. Because the stucco corners are most likely to be damaged during construction and when completed, the use of corner bead reinforces the firmness of the walls and saves a lot of time due to its easy construction. The corner guard bar is quick and easy to operate, reinforces the wall corner strength, and has a wide range of practicality.
Living room wall corner classification
Divided by material: metal corner protection strip and plastic corner protection strip; protection angle strip according to the use of the location is divided into: the angle of the sun corner protection, corner protection corner section, bendable corner protection strips, T-type corner protection strip; corner protection Article can also be divided into insulation corner protection and decoration corner bar.
How to install a wall corner strip?
1. If the construction building body is less than 2 meters away from the ground, it can be operated with a level ruler. If it exceeds 2 meters, it must be hung. Construction on rainy days is prohibited.
2. After the finished wall is in the powder-smeared 4-6mm cement mortar, the corner netting is anchored on the wall from top to bottom according to the hanging line, and the wall is required to be compacted so that the cement mortar is poured out from the mesh hole. Out.
3, the next procedure takes more than 12 hours can be carried out above, to prevent the mortar does not solidify when the collision shift or deformation.
4, paste the corner guard net to be a special person to operate (requires the angle of the vertical net mounting mode, full mortar), the verticality of the control error within 2mm, to seriously operate to meet the requirements. The length can be cut arbitrarily.
Note: The installation of angle guard strips can be constructed in sections, and the mortar is uniformly applied. The construction must be carried out from the top down.
Above about the living room wall corner bar related information, small make up roughly introduced here! Did everyone read this and did they get new skills? The newly renovated living room must be cherished, it is very important to do a good protective measures! More home improvement knowledge, please pay attention to this site information!
Living room decoration
Gate Valves are called "full-flow" valves; there's a direct unobstructed path for flow right through the middle of the valve. A wedge-shaped brass gate is lowered into a machined slot to close the valve. They should either be completely open or completely closed. Water flowing through a partially open gate valve wears away the metal and causes the valve to fail over time.
Brass Gate Valve, Flanged Gate Valve, High Pressure Gate Valves, Water Gate Valves
ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.kingsir-valve.com